Long term Triumph Chopper project

CA members' and friends' choppers... Discuss and show off your chopper here. Send your photos and description to our email address

Moderator: Prof

Prof
Founder, Choppers Australia
Posts: 5735
Joined: Sat Oct 22, 2005 3:54 pm
Location: Willunga, South Australia
Contact:

Re: Long term Triumph Chopper project

Post by Prof » Tue Aug 07, 2018 11:19 am

Just looking back at your original photo of the frame on the table.

Frame is level. Girder touches the table top. Distance of rear axle plates to table top (less distance of girder axle hole from table top) is basically the amount you will need to raise the steering head if you keep the same rake and use a 19" front wheel with a 3.25 tyre on it... Less about an inch of sag in the girder you will get with the weight of the bike on it.
Chopit'nrideit... Prof

TriNortchopz
Posts: 28
Joined: Sat Feb 24, 2018 5:41 pm
Location: Haines Junction,Yukon, Canada
Interests: Choppers, nature, learning more about choppers

Re: Long term Triumph Chopper project

Post by TriNortchopz » Wed Aug 08, 2018 2:49 pm

This Thread: P&P girder from a month ago on Chop Cult may be of interest; the original poster needed a new shock as the original by P&P was rusted beyond repair, and interestingly, the spring was interfering with the upper cross link spacer. Measurement information is posted, with options for replacement shocks.
http://www.chopcult.com/forum/showthread.php?t=51863

El Skitzo
Posts: 718
Joined: Wed Sep 30, 2009 6:40 pm
Location: Perth, WA

Re: Long term Triumph Chopper project

Post by El Skitzo » Thu Aug 09, 2018 9:56 am

Wow some brilliant information there TriNortcopz! I'll keep that handy when it comes time to go through the front end.

Thank you!
65 Triumph Chopper (project)

Post Reply

Return to “Your Chopper Pics”